Resin Thread Spool Bracelet

I’m certain that each one crafters and embroiders shall be pleased with this bracelet because it’s product of spools! You’ll want epoxy resin, mould launch and conditioner, 9 mini picket spools, ⅝” tall x ½” diameter, spray acrylic sealer or Mod Podge, colourful thread or embroidery floss. Gripping every spool firmly with needle-nose pliers, use a hacksaw to fastidiously cut up 9 picket spools in half. Use positive grit sandpaper to easy and even out the cuts on the again of every cut up spool. Check every spool within the resin mould to verify it suits inside simply, with a little bit of room to spare. If a spool is just too thick, use the sandpaper to take away extra width from the again, then test the match once more. Proceed studying the tutorial right here.